Replacing the wheel rear bearings on your dirt bike is an easy job. The bearings are a press fit, so you will need fire and a hammer to remove them. The only specialty tool you will need is the bearing retainer tool.
The only parts you will need are a new set of bearing and seals to replace the old ones. You can get your new wheel bearing at Amazon.com!
You Can Get All The Parts And Tools You Need At Amazon.com!
The other tools you will need:
- A garage floor
- Two long 2x4s
- Socket and breaker bar for the axle nut
- Wrench for chain adjuster jam nut
- Wrench for chain adjuster
- A block of wood
- A Tire Spoon
- Bearing retainer tool
- Drift
- Socket for the inner bearing race
- Bigger socket for outer bearing race
- A socket wrench extension
- A Propane Torch
- A Hammer
- A finishing file
- Parts cleaner
- A Clean towel
- Safety glasses
- And Gloves
Related: Here’s how the rear wheel hub works on your dirt bike, in case you were wondering
Make sure to check out the full guide HERE.