How To Assemble And Install The Crankcase On Your 1997 – 2001 Honda CR250.
Give every bearing a coating of 2-stroke oil, and tape the splines of the crankshaft and transmission.
The Tools You Will Need Are:
- Crank Puller Tool
- 8mm Socket
- 1/4 in Socket Wrench
- Seal Sized Sockets
- 2-Stroke Oil
The Parts You Will Need Are:
Remember, you can get all the tools and parts for this service through our partner links. It won’t cost any more, and it helps us pay the bills!
Install the crankshaft on the right side first.
Assemble your crankshaft puller, and tighten the nut until the crankshaft is completely seated in the case.
The crankshaft will rotate during install, so make sure your connecting rod stays straight.
Flip the case and oil the bearings with 2-stroke oil.
Mesh the transmission main shaft and countershaft, make sure the washers are still on the ends of the gear stacks, and install them into the right case.
Install the shift forks.
The center fork goes on the main shaft, with the makings face down.
The left fork goes on the top of the countershaft, and the right goes on the bottom of the countershaft.
Install both forks with the markings facing up.
Install the shift drum.
Rotate the drum, so it engages with center fork pin.
Align the fork with the case bore, and install the short shift fork shaft.
Repeat with the left and right forks.
Check the transmission operation by turning the countershaft and shift drum.
The transmission may feel hard to shift, but remember that you are using your hand, not your foot, and the gears are meant to move side to side, not up and down.
Install the breather tube into the left case, and the block in the right case.
Install your new dowels and lubricated o-ring.
Place your gasket in the right case. Do not cut the top off yet.
Apply 2-stroke oil to the left case bearings.
Align the left case over the crankshaft and countershaft.
Assemble your crank puller, and begin joining the case halves. Work slowly, and use a mallet when needed.
Make sure to keep the case halves as even as possible.
With the crankshaft installed and the cases mated, install the NEW crank seals.
You can use a combination of the crankshaft puller to install the seals flush, and a large socket to seat it to the correct depth.
The left seal needs to be no more than 2 mm below the top of the bore, and the right no more than 1 mm below the top of the bore to allow for adequate lubrication.
Transfer your bolts from your holder back to the case. With the bolts in the correct place, apply thread locker.
Hand tighten the bolts first, then begin tightening in a criss-cross pattern, one-half turn at a time until tight.
These bolts have no torque specifications, so use a ¼ inch ratchet to tighten them firmly, anything bigger and you risk stripping the case threads.
Remove excess gasket material. Be careful not to let any gasket material enter the crankcase.
Bottom End Install:
Install the bottom end to the frame back side first. Install the two mounting bolts from the left side.
Reassemble the external shift mechanism and double check the transmission.
|Part 3: Bearings & Seals||1997 – 2001 CR250 Home|
Keep Your ’97-’01 CR250 Running Right!
- Service Specification
- Clutch Replacement
- Carburetor Service
- Engine Top End
- Front Fork Maintenance
- Rear Shock Rebuild
- Wheels & Tires
- Kickstarter Inspection
- External Shift Linkage